KATΑΣΚΕΥΗ PLL FM 300mW-FM COMPLET BOARD

300mW-FM 108 x 72 mm (width x height) (pcb)

1 TEXT 300 mWatts FM broadcast transmitter (87,5-108 MHz), 50kHz stepsize, dual-speed.
(Hartley oscillator version)

All component values are drawn on the .comp and .silklayer bitmaps, with the following
exceptions;

1.- mount a 10pF (1206 SMD-chip capacitor) between the base and collector of BC547
(this is the 'switch' transistor in the loopfilter section).
2.- L1 = 4.5 turns, 6 mm diameter, 1 mm CuAg, tap ¾ to 1 turn from ground (spaced)
3.- Cx = 3n9 (50µS) or 4n7 (75µS)
4.- JP1 = 2 pins header + jumper
5.- all 1uH and 0,1uH coils are ready-made molded type coils.

Notes

(*) not used
CuAg = silver plated copper wire
CuL = magnetwire, enameled copper wire
(Note: 1 mm CuL approx. equals to AWG18
0,3 mm approx. equals to AWG28)
(I) all diameters are measured from the inside of the coils

The green led indicates if the PLL is locked
The red led indicates if the PLL is not locked
___________________________________________________________________________

LCD CONECT

300 mWatts FM-transmitter display connections and pinout 14- boxed header

                               v

       13   11   9   7   5   3   1
       O   O   O   O   O   O   O

       14   12   10   8   6   4   2
       O   O   O   O   O   O   O

Connector   16F84(A)   L.C.D.
       16F628(A)

1       9      14
2       10       4
3       8       13
4       11       ‘Down’ button
5       7       12
6       12       ‘Set’ button
7       6       11
8       13       ‘Up’ button
9 (ground)   5       5
10 (ground)   5       1
11 (+5 volt)   4, 14       2
12 (+5 volt)   4, 14       3
13       2       6
14       1            15 (backlight, pin 16 is connected to ground!)

Note:
Mount a single wire from the lcd (pin 2 or 3), this is the positive supply
for the pushbuttons (in case you panelmount them).

1 x 16 character display pinout:

1 = GROUND/ 0 VOLT
2 = POWER SUPPLY 5 VOLT
3 = SUPPLY VOLTAGE LCD DRIVER
4 = RS , REGISTER SELECT, LOW=INSTRUCTION, HIGH=DATA
5 = R/W, READ/WRITE, LOW=MPU to LCM, HIGH=LCM to MPU
6 = E, ENABLE
    R/W=Low : Data are takingover at falling edge
    R/W=High: Data can be read at E=1
7 to 14 = DB0-DB7, Data Bus software selectable 4 or 8-bit mode
15 = LED + (Anode of LED Unit)
16 = LED - (Kathode of LED Unit)